This project is for Quadcopter with Atmega328. I use arduino IDE to development and create CmProtocol library. The CmProtocol library handle communication protocol between remote controller and helicopter.
2013-03-21 - Create three folders for this project.
- Helicopter : for helicopter side.
- Protocol : for communication protocol definition
- RemoteController : for controller side
- Remove Helicopter.ino
2012-09-21 - [Helicopter] Implement L3G4200D and LIS3LV02DQ driver (initial, read value)
2013-03-13 - [Remote controller] Initial Remote Controller software architecture
2013-03-23 - [CmProtocol] Create android library framework
2013-04-17 - [Remote controller] Implement handleJoystick function to read joystick's ADC and remap it beas on different control
2013-04-23 - [CmProtocol] CM:get_command_info, get_payload_int. RC:reveiceCommandData
- [CmProtocol] CM:set_payload_int, speed, turn, direction(left, right, front, back)
2013-05-21 - [Helicopter] Initial Helicopter software architecture
2013-06-05 - [Helicopter] Add L3G4200[Gyro] and LIS3LV02DQ[Accelerator] driver and sample code
2013-06-02 - [Helicopter] Add LIS3LV02DQ setup, getValue function
2013-09-21 - [Remote controller] Initial button function
2013-09-27 - [Remote controller] Implement Led, Display Manager, Button, Calibration
2013-09-30 - [Remote controller] Extend LED number from 8 to 16 and add middle range for joystick
- [Remote controller] Enable the third shift register and fixed led don't work when the number is over 16